GREENWOOD WOOLSHEDS AND COVERED YARDS
GreenWood sells NZ-wide from several distribution centres located throughout New Zealand. The location of our distribution centres and sales-support reps enable us to service all corners of the country swiftly and competitively. In some areas of New Zealand, GreenWood is the largest supplier of sheds.
EXTRA WALL FRAMING
Take a good look at a GreenWood shed and you will see we normally add in an extra row of wall framing – to keep your walls straighter and stronger for longer
LONGER CLADDING SCREWS
All the cladding on a GreenWood shed is fixed securely with 65mm screws – no nails and no shorter screws here!
HEAVIER FLASHING AND RIDGING
All flashing and ridging is 0.55mm thick – we don’t use the thinner 0.4mm flashings or ridging which some builders say can be flimsy and bend easily.
“BIRD-PROOF” ROOF FRAMING
All standard GreenWood sheds have our “bird-proof” roof framing system.
BUILDING CONSENT
Application form completed (but councils’ consent fees additional)
HEAVILY BRACED
High strength poles and steel MULTI-Brace roof bracing – we do not use the much lighter and narrower steel STRIP-Brace for roof bracing.
VERY GOOD PRICES
That’s a promise.
NATIONAL COVERAGE
Through our distribution centres around the country we can deliver to any part of NZ, including Great Barrier and Chatham Is.
Experience
Over 19 years we have always maintained our commitment to designing and supplying very strong, very durable buildings. Even during a recession, our commitment remains firm in delivering a high level of structural integrity in all our GreenWood buildings.
GREENWOOD WOOLSHEDS AND COVERED YARDS
Key Assumptions
Key assumptions – High wind and 0.9kpa snow load assumed, Good Ground, level site, good access. Prices may vary subject to location particularly for remote farms, approximate only, and may change without notice. All sizes, dimensions are approximate only and may be adjusted slightly depending on the shed. Assumes designed to Importance Level 1. GreenWood Ts and Cs apply. No fire engineering (if required by council) allowed for, or any other specialist costs (ie drainage).
Optional Extras Beyond Standard Include:
GreenWood Barn Shed Standard Kitsets
- Non-essential flashings.
- Lockable Roller and PA doors.
- Apron front ~ Extended Front.
- 1.1mm clear Duralite corrugate (to let light through).
- Clear spans up to 20m.
- Netting and building paper.
- Spouting and downpipes.
- Any further costs beyond Standard Kitset.
- Reinforced concrete floors.
- Fully engineered working drawings – every shed is designed for high wind zone AND 0.9 kpa snow load as a minimum.
- High Strength H5 Poles.
- No1 Frame timber (or better).
- GreenWood has 2-3 long term supplier relationships for coloursteel and zinc cladding.
- Fixings and steel bracing – all galvanised as std.
- GreenWood reserves the right to upgrade, change or modify our specifications without notice.
Shed Dimensions
Dive into a plethora of options:
Number of Bays
Options range from 1, 2, 3,… up to 25.
Bay Widths
Options include 3.0m, 3.6m, 4.0, 4.2, 4.5, 4.8, 5.4, 6m and more.
Height
Any heights from 2.4 right up to 14.0m.
Depth
Any depths from 5m up to 35m. Common depths are 6m, 7m, 8m, 9m, 12m, and 15m.
Woolshed Price Estimates
Sizes (suggested sizes only)
2 stand: 11.6m x 10.8m = 125m2
3 Stand: 17×10.8m = 183m2
4 stand: 13.5m x 18m = 243m2
6 stand: 16m x 22.5m = 360m3
Height
4.8-6.0-4.8m, standard Gable design
Doors
2 x roller doors (2.4m h x 3m w), 1 x PA door
Windows and Clearlight
2 and 3 stand woolsheds – 2 windows, 15m clearlight
4 and 6 stand woolsheds – 3 windows, 25m clearlight
Windows above are 1.2m h x 1.8m wide, each with an opening pane, single glazed
Cladding
Zincalume corrugate cladding. For colorsteel add c. $20-22 / m2 + gst
Landing and Stairs
Landing and stairs, and sheep ramp into shed
Structure
Structure – poles, timber, hardware, clearspan rafters over woolroom, (tek screws for all hardware). All hardware galvanized.
Assumes two sides are part-open (from the ground up to just below the mid-floor structure). This to allow access and ventilation into under the shed
Pricing allows for large clearspan over the woolroom
White synthetic roofing paper in the roof supported by Roof-safe netting
Zinc steel gutter
Barge flashings
No allowance for fitout in this section
Prices
Woolshed less than 120-140m2
$340-350/m2 + gst. Construction – $140-145/m2 + gst
Woolshed 160 – 200m2
$300-320/m2 + gst. Construction – $135-145/m2 + gst
Woolshed 201 – 300m2
$260-280/m2 + gst. Construction – $135/m2 + gst
Woolshed more than 300m2
$245-255/m2 + gst. Construction – $115/m2 + gst
Covered Yards Estimate
Covered Yards Estimate
Sizes
2 stand – 11.5m x 20 = 230m2
3 Stand – 14m x 22.5m = 315m2
4 stand – 18m x 22.5m = 405m2
6 stand – 18m x 30m = 540m3
Design Details
As a general rule, allow 2.2 woolly ewes per m2. Exclude concreted areas from overnight areas for sheep.
Standard gable design, and connected to woolshed.
Heights – assume 2.8-3m knee – to an apex of approx 4.0-4.2m high (depends on size).
At least 2 x clearspan rafters spanning min 50% of the shed depth.
Roof plus two / 2 walls included. 2 sides open.
Zincalume corrugate cladding. For colorsteel add c. $15/m2 + gst to upgrade both the roof and two walls to colorsteel.
Clearlight in walls and / or roof.
Covered Yards less than 400m2 – 25m clearlight
Covered Yards more than 400m2 – 45m clearlight
Structure
Structure – poles, timber, hardware (tek screws for all hardware)
Prices
Covered Yards less than 250m2
– Materials – $135-150/m2 + gst. Construction – $85/m2 + gst
Covered Yards more than 251-350m2
– Materials – $120-140/m2 + gst. Construction – $80/m2 + gst
Covered Yards more than 350m2 -479m2
– Materials – $110-125/m2 + gst. Construction – $78/m2 + gst
Covered Yards more than 480m2 +
– Materials – $100-108/m2 + gst. Construction – $76/m2 + gst
No fit out under covered yards allowed for
Internal Fitout of the Woolshed Estimate
Woolroom and Shearing Board Area
Approximately 50% of floor area.
Clearspan over woolroom.
Board is hardwood T&G flooring and is a minimum of 1.6m wide x approximately 2.5m long per shearer.
Walls in Woolroom lined up to 1.2m high above the floor.
Height – mid-floor level approximately 2.1m above ground level.
1m x 4m hardwood floor or treated ply inside the main slide door from the load-out platform (for improved durability against the weather).
No raised board allowed – flat floor assumed.
Mid-floor Structure
Poles and piles, with bearers and joists, flooring panels, premium pine ex 50×40 grating.
No fitout of pens under the midfloor.
Size of Pen area in the back of woolshed – approximately 50% of floor area.
For each stand, there is a chute, catching pen, pen door with a bottom flap and back-pad.
In pen area – holding pens, grating, outer walls lined with rails. All catching pens have rails on both sides of posts.
Headboard above catching-pen doors for your shearing plant.
Lift “n Swing steel gates.
Both Woolshed and Covered Yards Details
Both woolshed and covered yards designed to Importance level 1. If council requires the woolshed to be designed to Importance Level 2 (i.e., “commercial” end use), there will be extra costs.
The deposit paid for the woolshed “shell” will be adequate to cover the deposit for the fitout. The engineered design for the fitout is included in the fitout costs.
Exclusions (may not be an exhaustive list):
No electrical / plumbing.
No paint or any other finishing stains / oils / polyurethane coatings.
No shearing plant.
No fire requirements (if any).
No yarding materials under midfloor in woolshed.
No yarding or any fitout in covered yards.
No toilet.
Prices (PROV COST PER STAND)
2, 3 stand Materials/design $18,500-19,500+ gst. Assembly $13.5-15,000+ gst.
4, 6 stand Materials / design $17,500-18,500+ gst. Assembly $12-13,000+ gst.